Water-Based vs. Oil-Based Polyurethane Floor Finish |Notorious Flooring Tip!

Water based and Oil based Finish

Both water based and oil based poly offer good protection; the biggest difference is in appearance. If you love the natural look of maple, apply a water-based (waterborne) polyurethane. They appear milky in the can, but go on clear and remain clear. They’ll slightly accent the character of your wood without giving it the amber tint of an oil-based poly. (However, some woods, like the oak shown, cry out for that amber tint.) Water-based finishes dry fast—most within two hours—so you can apply several coats in a day and use the room that night. They have minimal odor and clean up with water too. But water-based polys have their tradeoffs. They cost twice as much as oil-based polys. They won’t give wood floors the rich glow that oil-based polys impart; some even consider them cold looking. Most water-based polys contain only 30 to 35 percent solids, compared with the 45 to 50 percent solids in oil-based products. Since these solids create the protective finish, you need to apply four coats, as opposed to two or three. And you may need to apply additional coats every two years or so. There’s debate over which finish is harder, but some experts maintain that hardness isn’t necessarily a good attribute of a floor finish. You want a finish that will flex along with the floor. And a super-hard finish shows scratches more readily. You’ll prolong the protective life of any finish by eliminating its No. 1 enemies: dirt and grit. Sweep or vacuum the floor often and put throw rugs in high-traffic areas.